Page 48 of 67

Re: What did you work on today?

Posted: Tue Jan 25, 2022 5:24 pm
by gots_a_sol
Wrapped up the lowering job. Threw new front struts on that were for a 2wd truck which lowered the front another inch. Shorter rear shackles raised the rear up an inch. Now with about 5 psi in the air bags the rear is about an inch higher than the front, which is just what I was after.

Probably going to zip off the running boards as not really necessary any more.


Image

Re: What did you work on today?

Posted: Tue Jan 25, 2022 7:19 pm
by aai
Good looking truck! I agree it would be cleaner without the side steps, the front air dam as well, could ruin it on a parking curb. Last trucks I lowered were my ram RT trucks with Mcgaughy kits. Just 2/3 kits and added appropriate air lift bags to do truck stuff still. Never had the skills to do the job you did on yours but always admired them, drop spindles etc


Sent from my iPhone using Tapatalk Pro

Re: What did you work on today?

Posted: Tue Jan 25, 2022 9:01 pm
by smdub
You're lowering your truck yet I keep eyeing the LMTV that is parked near our office. I hear some of them have a small crane. Would be useful(necessary?) to load bikes onto it.

Re: What did you work on today?

Posted: Wed Jan 26, 2022 2:23 pm
by J&J
Shop progress…
Image
Image
Image

Re: What did you work on today?

Posted: Wed Jan 26, 2022 3:31 pm
by juddspaintballs
Nice. One day I'll have a shop with a lift.

Re: What did you work on today?

Posted: Wed Jan 26, 2022 7:50 pm
by Bork
After seeing J&J 's nice lift, I dont think I need one. Where's your address? I hope it pick up my E350 diesel15 passenger ford van? :lol2:

Re: What did you work on today?

Posted: Thu Jan 27, 2022 8:41 am
by Skinny-J
Where did the boat go?

Re: What did you work on today?

Posted: Thu Jan 27, 2022 1:14 pm
by motorider
That’s a sweet lift! I’ve been trying to work on my bikes in the garage but my electric heater is not up to the task. Runs all day and only gets to 40 degrees. Anyone have suggestions for portable garage heaters?

Re: What did you work on today?

Posted: Thu Jan 27, 2022 2:09 pm
by Laoch
motorider wrote:
Thu Jan 27, 2022 1:14 pm
That’s a sweet lift! I’ve been trying to work on my bikes in the garage but my electric heater is not up to the task. Runs all day and only gets to 40 degrees. Anyone have suggestions for portable garage heaters?
Propane "jet" style heater. It will have you opening the doors.

Re: What did you work on today?

Posted: Thu Jan 27, 2022 2:11 pm
by J&J
Bork, lol like having a truck when somebody needs to move something right? And you might need a friend with a bigger lift. This is a 10k but vans need some height.

SJ, I scrapped the boat, sold the trailer and motors a while ago. I collect projects and that one was too much without the uncle that was going to help.

Motorider, I have a heat pump/ac unit but heat with a wood stove. Wood is a pain and messy but cheap for me. Insulation is the key, it will stay above 40 for days. I also have a large kerosene heater but it’s very loud and toxic without ventilation. It will knock the chill out of there in 15 minutes though.

Now back to the Mustang Coyote swap project…