Page 1 of 1

I Blew A Seal

Posted: Mon Nov 09, 2009 8:18 pm
by jxs2151
Fork seal. Either I rode it too hard in the Barrens or what they say about cinching the front down too tight is true.

Re: I Blew A Seal

Posted: Mon Nov 09, 2009 8:32 pm
by Hare
it could have a speck of dirt in there, you can use a small screwdriver on the outter edge of the outtermost seal, usually called a wiper. Then get some roll off film and slip it up pass the seal and fork tube then pull it out while rotating around the tube, many times i saved a leaking seal.

Re: I Blew A Seal

Posted: Mon Nov 09, 2009 8:32 pm
by Rut Row
blew a seal? would that be Ring or Harp? :jack:

Re: I Blew A Seal

Posted: Mon Nov 09, 2009 9:00 pm
by hondahawkrider
Kyler wrote:blew a seal? would that be Ring or Harp? :jack:

Hey what Jeff does on his own time....................

Re: I Blew A Seal

Posted: Mon Nov 09, 2009 9:25 pm
by mdubya
jxs2151 wrote:Fork seal. Either I rode it too hard in the Barrens or what they say about cinching the front down too tight is true.
A couple of ratchet straps around the swing arm, near the rear axle will really stabilize the bike and allow you to not have to crank the front down so hard.

Re: I Blew A Seal

Posted: Tue Nov 10, 2009 7:02 am
by B DIRT
are you sure it wasnt that fish sandwich you had for lunch? oh and the myth about strapping the bike down to tight is bull shit :thumbup:

Re: I Blew A Seal

Posted: Tue Nov 10, 2009 9:20 am
by OldmanX
Hare wrote:it could have a speck of dirt in there, you can use a small screwdriver on the outter edge of the outtermost seal, usually called a wiper. Then get some roll off film and slip it up pass the seal and fork tube then pull it out while rotating around the tube, many times i saved a leaking seal.
X2 on the film idea. Providing that you don't have a mark on the fork tube that damaged the seal, dirt in the seal is the most likely suspect. For film, I use the plastic sheets from our office laminating machine.

Re: I Blew A Seal

Posted: Tue Nov 10, 2009 4:17 pm
by jxs2151
What are you guys talking about dirt and screwdrivers?

I was merely commenting on my deviant oral sexual behavior with pinnipeds.

Seriously, thanks for the advice. I'm gonna look into the suggestions.

Re: I Blew A Seal

Posted: Tue Nov 10, 2009 5:52 pm
by Roadracer_Al
Reminds me of an old joke.

A penguin was driving down the street, and noticed a horrible cloud of smoke behind his car, so he pulled into a mechanic's garage.

The mechanic says "It'll be about an hour for me to figure out what's wrong." So, the penguin goes to the diner across the street and eats lunch.

An hour later, he comes back and the mechanic says "It looks like you just blew a seal." The penguin says "Oh, it's just ice cream."

Re: I Blew A Seal

Posted: Sat Dec 05, 2009 4:24 pm
by frogman1981
I put a short piece of 4X4 between the tire and fender(between the forks), then ratchet the front.